0
Add your answer:
Earn +20 pts
With lights off What causes the left headight motor to keep running on a 1985 corvette?
Failed limit switch, or bad wiring. The motor will keep running until the headlight finds "home" ... ergo a failed limit switch as mentioned above. The sensor at the "home" position (headlight off) has to be tripped by the headlight assembly before the motor will shut down. The motor has no idea where the headlight physically is ... it keeps running until the switch is engaged.
Why will home electric switch for pool pump not throw it is stuck in off position?
YOU seem to NEED A 2-POLE SWITCH. GO TO HOME DEPOT or the hardware store of your choice. BUT IF YOUr MOTOR IS BAD, A new SWITCH won't FIX IT. It MIGHT NEED BEARINGS, SO FIND YOUR LOCAL MOTOR REPAIR SHOP AND HAVE THEM TEST IT.
What is an icc switch on Chevrolet dash?
The ICC switch is for flashing the parking/clearance lights. It's used when passing another vehicle to thank them when they flash their headlights to let you know it's safe to move in front of them. It stands for the old Interstate Commerce Commission.
On a 98 Chrysler minivan why do the wipers stop anywhere on the windshield and not at the bottom?
There is a switch inside the wiper motor that identifies the home spot for the wipers. If you have intermittent wipers there is also a controller for that. Either can give you problems but more likely the wiper motor switch. The wiper motor switch usually is not a separate part (comes with wiper motor assy.) Oh yeah, 1 other thing, be sure the wiper arms are installed correctly on wiper motor.
Can a single pole switch replaced starter?
If you are talking about motor control then the answer is yes. There are two things to take into account though. One, is the motor thermally protected. This is for overload protection. On fractional HP motors it will indicate this on the nameplate. If the motor is not protected, then a fractional HP motor switch should be used. Incorporated into this switch is a heater element that the motor current flows through. If the motor current gets over the motor nameplate rating then the heater trips the switch and shuts the motor off. The other thing is that the switch has to be motor rated, currents and voltage matching the motor nameplate ratings. The specific switch has been designed to open motor currents under full motor loads. An ordinary house light switch is not motor load rated and should not be used for this purpose.
Cavalier 2002 drivers power window seem to work on and off?
You are going to have 2 things to repair with this problem. The window switch and the window motor. The weak motor has melted the inside of the switch. Yep...been there,done that.Replacing the motor wont fix the switch and if you replace the switch the weak motor will melt the new switch.
How can you fix a nonstop moving wiper of a 1996 volkswagen jetta trek?
In general, most electric wiper motors have a "home" position at which the motor is to stop when the switch is turned off. If the home position is not detected there is probably a fault in the motor assembly.
Is Australia going to win the ICC Cricket World Cup in 2015?
Yes,Austraila has probability to win ICC WORLD CUP in 2015. Autralia will get benefits from home pitches.
Is there a way to tell if the power window switch is bad or if it the motor for the switch?
remove switch from where it is mounted using a wire , bridge the connections.if switch is bad, it will work the motor while bridged
Is the park switch on a 1976 Chevy pickup wiper motor in the pump or the motor?
It is in the motor.
How do you fix windshield wipers on a Honda CRV that won't turn off?
The motor needs to be replaced. There is a "switch" in the motor that "parks" the wipers. This happens when current is removed from the motor. Your "switch" in the motor is not allowing this to happen. Replace the motor.
Where is switch for air ride motor to come on after replacing the motor you turned on and off switch in trunk but motor does not run or will not come on to pump air 1994 Lincoln town car?
check fuse there is no switch or you a stuck pump
