A load bearing wall supports a structure or weight that is above it, transferring that weight to what is below the wall. Also - The most common, as easiest to identify is the exterior wall.
7.5 inch
LOAD BEARING WALLS Walls that must support the dead load of their own weight and the weight of subsequent bearing structural members placed upon them. In addition, load bearing walls must be capable to carry the load of "live" loads that are anticpated to be placed upon the the system without deflection that can degrade or negatively impact structural intergrity. NON LOAD BEARING Walls that are only intended to support themselves and the weight of the cladding or sheathings attached. Non load bearing walls provide no structural support and may be interior or exterior walls. Non load bearing walls must be braced to resist minimum 5 psf lateral loads.
A wall of a building that not only is used to separate rooms, but is also supporting the structure above it. Some people like to remove walls from their homes to open up rooms and spaces; however, you don't want to remove a load-bearing wall because the second floor or roof may be supported by this.
A typical load bearing header will be 2 2x12s with a 7/16 plywood spacer between them.
Lath and plaster is just an old type of wall finish. Like drywall is a wall finish. What the wall is constructed of underneath the lath and plaster and where it is placed in the building determine if it is load bearing or not. A lath and plaster wall could be load bearing or it might not be. IF it is an outside wall, it most certainly is load bearing. other than that, the best way to figure it out is to have a structural engineer tell you wether it is or not. Even if it is load bearing it may be possible to remove it if a beam is put up in place of the wall. Really, the best and safest way to decide is to have a engineer look at it.
Usually, a load bearing wall will be perpendicular to the roof ridge.
Load Bearing - something that bears a load. Like a load bearing wall in a house. The wall is holding something up like the roof, another floor, etc.
Yes, you can run electrical wires in a load bearing wall.
A load-bearing wall itself will not cause structural damage. However, if a load-bearing wall is removed without structural replacement, yes structural damage will occur.
A load bearing wall supports a structure or weight that is above it, transferring that weight to what is below the wall. Also - The most common, as easiest to identify is the exterior wall.
You will need to go to the level above the wall. If girders, joists or another wall is supported by your initial wall, then that becomes a 'load'. Supported by by the wall downstarirs, Thus bearing a load
A partition wall divides a larger space. Non load bearing means that it's not supporting the floor or wall above.
Center of a structure is usually load bearing. Look in attic or basement to see where the support is.
Non load bearing walls are walls that the weight of the roof is not supported on. Any wall that runs parallel will roof joists will be non load bearing.
If the wall is load bearing or you are not sure if it is load bearing I would definately hire a professional. If you are sure the wall is not load bearing and you have some basic carpenters skills this should be a manageable job for a homeowner.
A wall that bears the load of a roof, floor or another wall above it, is carrying a load other than its own weight and is called a load-bearing wall.