Wiki User
∙ 13y agoThe flash point of a fuel mixture like JP-5 and JP-8 can be estimated using the flash point values and the volume fractions of each component. The formula generally involves a weighted average calculation of the flash points of the individual components. The specific formula may vary depending on the behavior of the components when mixed.
Stearic acid has a minimal effect on the flash point of a substance due to its low volatility and high melting point. The flash point is primarily influenced by more volatile components in a mixture. As stearic acid is a solid at room temperature and has a relatively low vapor pressure, it does not significantly impact the flash point of a substance.
The flash point of a gas is the temperature at which it can ignite and produce a flame when exposed to an ignition source. It is an important safety measure for handling and storing gases to prevent accidents and ensure proper ventilation in working environments.
Paper towels are made from cellulose fibers, which are not flammable enough to have a flash point. Therefore, paper towels do not have a flash point.
The flash point of phosphate depends on the specific type of phosphate compound. In general, phosphates do not have a flash point because they are salts and not flammable materials.
The flash point of turpentine is typically around 95°F (35°C), while its melting point is around -30°F (-34°C).
it depends on the different types of waste a mixture would probably be close to the flash point of the lowest "ingredient"
Stearic acid has a minimal effect on the flash point of a substance due to its low volatility and high melting point. The flash point is primarily influenced by more volatile components in a mixture. As stearic acid is a solid at room temperature and has a relatively low vapor pressure, it does not significantly impact the flash point of a substance.
I'm not sure how you arrived at this conclusion, but it's incorrect. The flash point is defined as " the lowest temperature at which it can vaporize to form an ignitable mixture in air" - this temperature remains the same regardless of location.
The minimum temperature at which a material gives off enough vapor to form an ignitable mixture with air is called the material's flash point. It is an important safety measure in handling and storing flammable substances.
At room temperature carbon monoxide is a gas. It boils at around minus 191 deg C. By definition flash point is the lowest temperature a liquid material can vaporize to form an ignitable mixture in air. So probably the answer is the boiling point.
The flash point of a gas is the temperature at which it can ignite and produce a flame when exposed to an ignition source. It is an important safety measure for handling and storing gases to prevent accidents and ensure proper ventilation in working environments.
Flash point for ammonia is the point where it becomes flammable after a phase change from a liquid to gas forming a flammable mixture in air. Obviously this is different to the lowest flammable concentration in air. In the case of ammonia it is 11 degrees according to the MSDS: http://msds.chem.ox.ac.uk/AM/ammonia_anhydrous.html
What is the flash point of 1/2" osb
Flash point of min. 60 °C (140 °F).
Flash point of canola is approx. 425oC
The flash point of ethylamine is -37 0C.
What is the flash point of 1/2" osb