20 inches or 508mm
The most common shaft length for engines in the 90 hp range is 20 in., refered to as a long shaft. They also come in 25 in., extra long, and for special applications, 15 in. refered to as a short shaft.
By measuring the exhaust housing, between the powerhead, and where the gearcase bolts on. A shortshaft engine will have an exhaust housing length of approximately 15 in. The longshaft engine will measure 20 in.
Boat builders manfacture their crafts' in three basic transom heights. The transom height is measured from the top of the transom, (where the engine bolts on), straight down to the keel, (bottom middle), of the boat. A 15'' transom would require a shortshaft engine. A 20" transom would need a longshaft outboard, and a boat with a 25" transom, would require a extra longshaft engine.
The Evinrude 225 hp Ocean Pro for 1996 was produced in three shaft lengths, as designated by engine model number CXED - 25in. CZED - 30in. STLED- 20in.
Model number J20ELCCA is a 20 hp Johnson outboard, electric start, long shaft, 1988 model, outboard engine.
As long as the engine does not exceed the vessels maximum horsepower rating, it should be fine. The age of the motor, other than the condition of it, would not be a factor. The engine shaft length on the 115 is standard 20 in.
The dry weight for this engine is listed as 248lbs.
E -Electric Start XL - Extra long shaft PT - Power Trim O - Oil injection
The point at which the horsepower measurement is taken. A 100hp outboard engine may only deliver 87 horsepower to the propeller due to losses in the transmission and bearings. The engine horsepower is 100, but the shaft horsepower rating is 87 horsepower.
The top part of an outboard houses the engine. Most older models used a two stroke type where oil is mixed with the gas. The engines' vertical drive shaft is the slim middle part. At the bottom, a gear converts the vertical motion of the shaft to a horizontal one, to which is connected the propeller.
yes it can contact http://www.franzmarine.com/