What if your float is not floating? Food for thought... If your float has gone bad then it wil not give enough force to close the Float Valve. Get a new float. If this does not fix it then the float valve you got is defective.
If gas is coming out of the overflow tube on your CRF250R, it could be due to a stuck float in the carburetor. To fix this issue, try tapping lightly on the carburetor bowl to free up the float. If the problem persists, you may need to clean or replace the carburetor float valve.
Your float is stuck, a quick fix is tapping on the float bowl with a wrench or the handle of a screwdriver, but you need to tear your carb down and give it a good cleaning.
Remove the float from the Regal. inspect the float for leaks, then check the spring and needle valve as it could be stuck. If all parts are ok then the parts need cleaning as they are sticking.
either the floats are set wrong or the little valve under the float is sticking not hard to fix
how do i fix leaking spray pump on a 2 barrel carburetor
your float is set too high. get someone that knows what their doing to adjust it properly.
It doesn't have a carburetor, it is fuel injected. What seems to be the problem?
Fix the drive belt.
It will if that's what it needs and it is done right.
The carburetor gaskets are the most likely candidate. The carb gaskets in weedwackers act as a fuel pump. When the gaskets get stiff they no longer pump enough gas to feed the engine. The other possibility is a blocked carburetor passage or jet that is starving the engine, but my craftsman weedwacker had the same problem even after I cleaned the carb thoroughly. The gaskets were the fix. You can either have your carb serviced at a local lawn shop or if your good with small parts you can buy the kit and DIY.
thaks for tha help