Mix AExterior/ Exposed to dampnessArea of plaster per bag mixAll Purpose Cement Plaster thickness Area of wall (m2)Bags per (m2)110 mm120.08333333315 mm80.12520 mm60.166666667Mix BInterior/ Dry.Area of plaster per bag mixAll Purpose Cement Plaster thickness Area of wall (m2)Bags per (m2)110 mm150.06666666715 mm100.120 mm7.50.133333333
224
Could you indicate the height of the wall required please.
12 -4x8 sheets
Assuming you actually require 24 feet long and 6 high as a 6 wide wall will be only 4 inches high. The bricks required without cutting contingency is 803
you have to remove paint n rough the surface then put some cement slurry n paste the tile by cement
Not JUST a grout no. You can get a cement that will also work as a grout but a pure grout would not have the adhesion required to stick the tiles to the wall properly, you should not use it as a cement.
How much cement required for grouting of block (16"x8"x8") wall for 100 sft area
at present condition 10*10 room how much bricks and cement and iron rod and blue stone Required
It is certainly possible to tile a floor, but bear in mind, there is much more pressure placed on the floor than on the walls, and floor tile must be laid over a solid cement base, otherwise it is going to crack.
You need to put up cement board first then apply the tile. You can find on line DIY step by step instructions and pointers.
You will need about a bag of cement for this project. You will also need around 0.15 cu.m of sand.
Just the installation for a ceramic or porcelain tile will be around $3-$4 per sq ft for floor & $4-$5 for wall tiles. If you're talking marble, granite or slate it's gonna be in the $5-$6 per sq ft & $6-$7 for wall tiles.
not advised, wood expands too much
wall tiles are used on walls. floor tiles are used on floors. if you want to interchange. you can make the wall tile as floor tile and vice-versa
I am not an expert but from experience selling tiles the following are guidelines: 1. The type of surface determines how much cement to use 2.The quality of cement will also affect ratio 3.The area to be tiled e.g. wall or floor determines the quantity on average 2-3 squares meters will require one 20Kg tile adhesive
Chances of breaking the tiles are about 99% sure, taking tiles off are very difficult and trying to put them back on again is not easy as the tile cement will still be attached to the old tile and trying to chip the old cement off will result in breaking the tile however if you dont and put the tiles back it will result in a lumpy tiling finish. Doc says: Doc says that if you are trying to replace an existing shower valve without tearing out your tile wall then you should check out versi-shower.com. They sell shower units that mount to your existing tile and covers the area necessary to remove or bypass the old valve. Good product and cheaper than busting up your wall. -Doc