A standard toilet roughs in at 12" from the wall.
Chat with our AI personalities
Usually, most people will only use one type of toilet paper and then maybe a baby wipe as well. You will have to find the toilet paper that is right for you.
no not on the rough draft..... but on the good draft yes. YOU SHOULD KNOW
The standard toilet height is the same standard height of a chair which is between 16 to 17 inches. You can order toilets that are higher off the ground than that for older people who have a hard time getting up off the toilet.
Toilet sizes are dependent on several factors. Included are whether or not it has a tank, and whether it is free-standing or wall mounted, and then there are ranges within that.
A Rough Cost Estimate is an initial estimate that uses prior experience and other non-project data to estimate the cost of a project. It is also called a Rough Order of Magnitude (ROM) estimate, or a Conceptual Estimate. The Rough Cost Estimate is used for project screening, or deciding which among several projects to proceed with.
To measure the toilet rough-in without removing the toilet, you can use a tape measure to measure the distance from the wall behind the toilet to the center of the closet bolts at the base of the toilet. This measurement will give you the rough-in measurement, which is typically either 10, 12, or 14 inches.
The standard measurement for a toilet drain rough-in is 12 inches from the finished wall to the center of the drain.
The recommended depth for installing a rough-in for a toilet drain is typically around 12 inches from the finished floor level.
The minimum distance required is 15" either side/ that is minimum.
10"- 12 "- 14 "
It is not a problem at all. But you will have a 2" gap between the back of the tank and the finished wall.
life was rough then easy
To rough in a toilet during a bathroom renovation project, you need to first determine the location for the toilet and mark the spot on the floor. Then, install the toilet flange at the correct position and connect the waste pipe to the existing plumbing system. Make sure to secure the flange properly and test for leaks before installing the toilet.
The dimensions required for installing a Toto 10-inch rough-in toilet are typically a minimum of 10 inches from the wall to the center of the drain pipe. This measurement ensures proper alignment and fit for the toilet installation.
no because 14 is bigger than 12
18 inches to center
as far as i can see, nothing. it is just a trophy