In a toilet tank or water reservior to regulate filling.
Assuming you have a regular tank toilet with a ball float and rubber flap and that the water is turned on and the tank is filling, the most common cause of a toilet not flushing is a broken or detached chain that runs from the handle lever to te rubber flap that keeps the water in the tank.
The width of a toilet tank can vary in size. The average width of a toilet tank is about 18 inches.
If the toilet bowl fills lower than the previous waterline, the tank may not be working properly. Check that the float is moving freely and allowing the tank to refill all the way. Also make sure the filler tube is filling the toilet and is not directed elsewhere.
There should be shut off valve called an angle stop towards the floor on the left side of your toilet. If you shut this valve by turning it clockwise this will stop the feed of water to the tank of your toilet.A:Your float valve may be defective or worn out
you should try to look in the back of the toilet and search for any clogs in there while you flush it. if that isn't the problem then i don't know what it is
They are called tank bolts.
Toilet tank
Will a American standard toilet tank fit a glacier bay toilet
Yes, -but the tank is filling up and will soon overflow starting at the lowest toilet. Much easier to service or replace your septic pump .
The tank above your toilet.
Which part, the tank or the bowl? If it's the tank, you have a problem with a restriction between the tank and the bowl. If it's the bowl, you have an obstruction in either the neck of the toilet or the drain pipe below the toilet.