0
Add your answer:
Earn +20 pts
How should the ejector be lubricated on an m4 carbine?
Put a drop of lubricant on it then use a spent casing to push the ejector in and out to get the lubricant to the spring.
Is it ok to put WD-40 on an alternator belt?
Absolutely NOT! WD-40 is a lubricant. The last thing you want to put on a drive belt is a lubricant. If the belt is making a noise, it is either loose or worn out.
Who applies lubricant male or female?
It usually depends on what type of lubricant it is. An easy rule of thumb is that if it goes on yours, put on the lube. If it goes on theirs, let them do it.
Where do you put 80-90w oil?
80w90 is generally used as an axle lubricant.
What do you call a substance that is put on surfaces to reduce the friction between a surface?
lubricant
What do you call a substance that is put on surface to reduce the friction between the surfaces?
lubricant
What if you put water in your oil on a car?
It can cause engine damage, watert is not a lubricant.
What material is put on the gears and chain of a bicycle to make them work better?
A lubricant, like oil grease or wax.
How do you put compressor oil in a 2000 Kia Sephia?
Compressor lubricant is mixed in with the freon and will enter the system when it is recharged
How do you speed up the power window on a 1997 Toyota Camry?
You have to put some lubricant on all sliding parts (power window mechanism). You might need to put a little bit of lubricant in between glass and rubber parts too. Also you might have to clean certain parts of the mechanism if it was contaminated before.
If you put your hand up your bum would it get stuck?
well it depends how big your hand is an if you use the correct lubricant. i recommend JELLY... :/
What would happen if you put brake fluid in the power steering?
Your power steering will fail because brake fluid is poor lubricant.
