GAS.
Answer:It depends on what kind of hole. In a body panel, you might use bondo, fibreglass, or sheet metal. You'll have to ask a more specific question for a more specefic answer.No it cann't unless the hole is bloked.
Yes, you can fill in a hole, you can not fill out a hole
Fill it till it runs out of the fill hole. Again that's the FILL HOLE, not the DRAIN HOLE. They are separate.
The fill hole is the dipstick hole itself. You usually need a long funnel to get fluid into it, and it's slow to fill because of this.
can you fill the coconut with water wthout making a hole
If it is an automatic, there should be a drain hole on the bottom of the transmission and a fill hole on the side. I will have to look at mine though because i forgot what side it was on for the fill hole.
Fill it until the oil just starts to dribble out of the fill hole. If you over fill it just leave the fill plug out until oil stops dripping out of the fill hole. Don't try to fill it through the top where the shifter goes. Re install the tranny so that it is sitting at the normal angle of a car on its wheels, otherwise you could overfill it and blow out the oil seals.
if it is a big hole yes but if it is a small hole they will fill it in
There is no hole in Global Warming. There is a hole in ozone layer.
you have to go from under the car on the drivers side. there is a dip stick/fill hole
Fill level is to the bottom of the fill plug hole, approx 2 quarts.Fill level is to the bottom of the fill plug hole, approx 2 quarts.
you must have the car on a lift or jack stands and level as you will need to be under the car with the engine running. Take off the transmission bolt that is on the side of the pan.The fluid should be to the at the bottom of the hole. Fill with the proper fluid till it starts to flow out. The engine must be running when you check or fill as the fluid will come out after taking the bolt off without the engine on. You will have to fill through the same hole.