The oil filter probably needs changing after sucking up all the gook at the bottom of the tank, after that the filter can and fuel lines will need to be bled of air. The reset you are pressing is the flame failure safety because not enough fuel is getting to the nozzle for proper ignition. In addition, once you do all this and get it going you may have a smoky mess for awhile. At the first restart, depending on how many times you reset the flame failure control, the fire box has unburned fuel sprayed all over the inside it and once the burner lights, that fuel has to burn off and I`ve seen some ugly ones.-Good Luck
ignition on.. using button on end of stalk scroll through to service indication.. press button at least eight times... ignition off.. ignition back on and all reset
On the bottom left of the instrument cluster, is a button marked 0. Switch ignition on and immediately press the button. Switch ignition off. Press and hold the button while switching the ignition on. After 10 seconds, the new interval will appear, accompanied by a beep. Release button. Switch ignition off.
Press odometer button and turn the ignition on, then release odo button and press minute button, thats it. ;)
Turn the ignition switch to off, then press and hold the service wrench button. While still holding the button, turn your ignition to on without starting the car. Press the clock button marked "Min" and then release the wrench button.
Open door Turn ignition on press valet button on and off 3 times (you will hear chime) press lock button turn ignition off DONE!!
the Y button is the button to be pressed at the time you need to press the Y button. at that time.
ignition on press reset button on left hand side of instrument cluster twice ignition off hold in reset button ignition on keep holding button in for 10 sec- release.
If your 300zx has no power to the entire car and the key is stuck in the ignition you have to press the emergency button located in the ignition. Simply remove the black piece from your ignition.(its a black cap)..and when removed you will see a small red button..if you see that push that and press the "push" black button, turn your key and pop it out.
we found out that we need to press the ignition "reset button" where is this?
To set the clock on your 1994 Cadillac DeVille, turn the ignition on with your key. On the bottom right corner of the clock you'll find the 'set' button. Press the button and immediately press and hold the 'seek' button. When the clock gets to the hour you want, release the 'seek' button. Next, press the 'set' button again and press the 'scan' button, and hold it while it scrolls through the minutes. When it displays the correct minutes, release the 'scan' button.
If you have a manual tranny, keep the clutch out and press the ignition button.
Switch the ignition on Immediately press the button located to the left of the speedo twice turn ignition off Press and hold the button whilst turning the ignition on after 10 seconds the new interval will appear accompanied by a beep release button turn ignition off I hope you found this helpful best wishes Mike