First disconnect your battery since you're working on an electrical component. Then locate your starter. The easiest way to do this is to buy a new one and look for something under your car that looks just like it. Most of the time the starter is on the passenger side of the engine and most likely on the rear half of the engine close to the transmission housing bell. Make a diagram, if it helps, or just remember what wires go where on the terminals of the starter solenoid. Then, there are probably three or four bolts that connect the starter to the car. Unscrew these and pull out the old starter and put the new one in and bolt it back on. Connect your wires how they were on the other one and reconnect your battery and you're ready to go! Make sure the wires are connected properly or it could fry the new starter!
Alero
Where do u install a relay flasher on a 2002 olds alero
replace a water pump on a 2004 olds alero 2.2 litler
== ==
Replace it. Sensor 2 is the one AFTER the catalytic converter.
It is located behind the starter. You'll need to remove the starter to replace it.
how do you replace a starter on a 1998 cutlass
The factory made the Olds Alero do that, I have a 2001 Olds Alero and it does the same thing. It's just a factory thing that they have done to the car.
alero intake manifold torque specs
If it is a V6, it is located in front between engine and the cooling fans.
yes it does i have a 2003 olds-mobile alero v6 sedan and the governor stops the car at 110mph
NO