clean oil from rubber
Motor oil will soften the rubber bushings if allowed to absorb. Clean it up asap.
twist the old one off, make sure the rubber seal came off with the old filter. Then rub some oil on the new filter, and thread the new one on the motor.
could be oil burn off from the leak Or during repair, the relative dripped oil on the motor, and the excess is burning off when the motor gets hot!
A great way to get motor oil off your hands is to use olive oil: Squirt some olive oil on your hands, rub your hands together to get the motor oil dissolved, then use soap to remove the mixture. Works great, doesn't leave your skin dry and irritated like solvents do.
No you do not, you would put oil on a oil filter gasket if it is a spin on type, this stops the rubber from binding and helps it seal.
If the motor is healthy, the oil will burn off in a moment or two.
you have to pull the motor and when you get the motor pulled take the oil pan off and the oil pump is in there ity will have a tube with a screen on it good luck
you will have to raise the motor up by taking the motor loose at the mounts just enough to get the oil pan off.
it is on the rear of the engine below the engine. There is a rubber hose coming out of the motor and the drain plug is inside the rubber hose.
decreased temperature
You have to hoist the motor up just enough to get it off take the motor mount nuts off there is a filter inside the oil pan tht is holding it