How did that even happen. You can't.
I am asking too!
Use double sided tape and stick it back on flat.
Yes. The clear cover is stuck on with double sided heavy duty tape. You don't have to take any screws out to take the cover off. Nextel would not supply a new cover, I found on at another locale. Reinstall with double sided tape.
No, duct tape can't set off a metal detector.
California Scents, air freshener. Spray, within minutes it peeling off. Another spray and set a minute, the rest of the residue will rub right off. Little elbow grease, and freshens the air. We use it with out remodeling company! Katie
Double sided tape or spirit gum ( you must not be sweaty when applying spirit gum or they will fall off! It is best to do this at least an hour before the performance)
To remove double-sided tape from glass, you can try applying heat from a hairdryer to soften the adhesive and then gently peel off the tape using a razor blade or a plastic scraper. You can also try using a commercial adhesive remover or rubbing alcohol to help dissolve the adhesive. Be sure to clean the glass thoroughly after removing the tape to remove any residue.
you could lay a piece of duck tape sticky side up and lay on top of that another piece of duck tape so the 2 sticky sides are facing eachother there fore there should be a double sided peice of duck tape if there is any stickiness left one the sides all you have to do it cut it off with a pair of scissors ( it doesnt matter whot kid of scissors)
Most trim is held on with double sided tape. Clean the old adhesive off the the back of the molding and the area of the car where the trim goes. Go to autoparts or paint supply place and get 3M double sided tape. It comes in several widths. Get the one that fits closest to the one you need. Clean the area of the car with some clean rubbing alcohol. Then reatach the molding to the car. Hope this helps.
First, get a small piece of wrapping paper which can wrap around your finger, it must be a square shape. Roll it up into the thickness, size & shape of the ring you want and press down hard. Quickly wrap transparent tape around the whole thing leaving a suitable hole to put your finger through. (Optional ->) Then get a small plastic model big enough to tape on the base or make a mini origami and stick it on with a piece of double - sided tape. Cover any excess parts of the double side tape with art glitter and your ring is ready to go! Made by Me! You might just want to cover your outside of the ring with double sided tape and sprinkle it all in your fave glitter or get a shaped hole puncher and punch it through thin, double sided tape, taking the shape or piece of tape, leaving the other bit behind and wrapping about your ring, then sprinkling glitter over the top and shaking the extras off!
You can remove double-sided tape from glass by using a mixture of equal parts water and vinegar to soak the tape, then use a razor blade to gently lift and scrape it off. Alternatively, heating the tape with a hairdryer can also help soften the adhesive for easier removal. Always test in a small inconspicuous area first to ensure it does not damage the glass.