The EGR on a 2007 is not vacuum controlled.
Check engine light on
EGR Valve is located in the rear of the engine, on the passenger's side. To access, you must remove the intake plenum.
Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.
The EGR sensor is part of the EGR valve on the rear pass side of the engine.The EGR sensor is part of the EGR valve on the rear pass side of the engine.
Yes, the engine can still run with the EGR vacuum solenoid not in the working condition.
It is called the egr tube.
the egr sensor is located on the engine compartment firewall next to the egr solenoid
The egr valve on a Chrysler Pacifica is on the front of the engine. It is near the top, behind the water pump.
EGR is on the top of the engine next to the throttle body. If your looking at the engine from the front. It would be to the right of the black valve cover and to the back. That is the egr valve, from 1994 and up the egr solenoid is located under the car above the starter.
The Haynes Automotive Repair Manual (for Chrysler Cirrus Dodge Stratus Plymouth Breeze)1995 - 2000 shows the EGR Valve on the BACK of the engine block (passenger side) with the Solenoid/Transducer mounted just above it. (Figure 6.1a - Page 6-13). Tubing runs from the Exhaust system to the EGR Valve and from the EGR Valve to the Solenoid/Transducer and from the Solenoid/Transducer to the Intake Manifold. Try following the tubing. ...
The EGR (Exhaust Gas Recirculation) valve opens when vacuum is applied. The EGR vacuum solenoid opens and closes the vacuum supply to the EGR valve when it is commanded to do so by the ECM (Engine Control Module).