where do u put hydraulic fluid in a Massey Ferguson 275
On the left side of the gear shifters
To change the hydraulic fluid in a Massey Ferguson 471 tractor, you will first need to locate the hydraulic fluid reservoir. Next, drain the old fluid by opening the drain plug and allowing it to empty completely. Once drained, replace the drain plug and refill the reservoir with the recommended type and amount of hydraulic fluid for your specific tractor model. Be sure to check for any leaks and test the hydraulic system to ensure proper functioning.
To check the hydraulic fluid level in a Massey Ferguson 245, you will first need to locate the hydraulic reservoir, which is typically located near the back of the tractor. Next, ensure the tractor is on a level surface and the engine is off. Remove the dipstick or sight glass from the reservoir and wipe it clean. Reinsert the dipstick or check the sight glass to see if the fluid level is within the recommended range. If the fluid level is low, add the appropriate type of hydraulic fluid until it reaches the correct level.
thru the dipstick and vent hole by your bucket levers
finger it
from back of tractor right side below cab in front of rear axle a small dip stick is located.
There is a spout on the rear close to under the seat. See picture
Hydraulic oil sight gauge and filler cap are located on back side of tractor below the big red warning triangle. Sight gauge is a small round window. Do not run without hydraulic fluid, it services the transmission too !!
To the left of the gear shift lever, large plug on top of transmission. Fill here,
Right side of engine right past the cab if it has one.
The dipstick for the hydraulic fluid is hard to see straight on. If you stand behind the tractor and look behind the right arm of the three point hitch you will see a yellow dipstick. The dipstick is scored on either side to indicate min and max levels,