0
Add your answer:
Earn +20 pts
What is the main function of the pwc's ignition safety switch?
To kill the engine if the operator is thrown out
What is main function of an ignition safety switch?
to shut off the engine if the operator is thrown overboard
What is the main function of an ignition safety switch?
to shut off the engine if the operator is thrown overboard
What is the main function of a Ignition safety switch?
PWC's (personal water craft) Ignition Safety Switch is used to shut down the Engine if the Operator loses control or thrown off of the water craft.
What is the main function if an ignition safety switch?
To not allow the engine to start unless the shift is in park or neutral in an automatic or the clutch is depressed in a standard transmission.
What is the main function of an ignition switch?
to shut off the engine if the operator is thrown overboard
What is the function of the Neutral Safety Switch on a 1998 Ford Windstar?
The Ford Neutral Safety Switch is an electronic part with the main function to stop the vehicle from getting started while in gear. The truck will not start when the switch is faulty.
What is the main function of the ignition safety switch?
To prevent the engine from being started while the transmission is any gear other than park or neutral.
2000 Toyota Camry have a ignition switch fuse?
A 2000 Toyota Camry has an ignition switch fuse location in the main fuse panel. It helps protect the switch and the rest of the ignition system from surges.
What is an ignition switch in a car?
an ignition switch or starter is a switch that activates the main electrical systems of a vehicle. This normally powers the start motor that turns the engine in the starting up process. . Most vehicles do not have an ignition switch anymore the key in the cylinder acts as the "switch"
1993 mercury sable won't start Good starter and solenoid Lights come on all the electrical stuff starts there is no crank or click of the solenoid?
Answercheck the solenoid wire at started for power when switch at start position.If no power, check neutral safety switch, or main ignition switch on steering column under dash.NOT the key tumbler assembly it has a rod that goes down column to the ignition switch
How do you replace an ignition switch for a 2000 blazer?
You will need to remove the retaining ring at the top of your 1978 Chevrolet Blazer ignition switch. Slide the ignition barrel out and remove the wiring harness. Reverse the process to install the new ignition switch.
