avoid thrust
to mitigate the axial thrust.
First off where is it? If it is in line then you can cut that section off and replace it with rubber fuel line of equal size.
You can cutoff the rear brake line. You will no longer have rear brakes and the fluid will leak out. It is not recommended that can't off the rear brake line, without replacing it.
Unless you dug the whole line up you probably wouldn't find the leak unless it was a very large leak which would bring the water to the surface, You would be better off just installing a new line. Call a leak detection company. They will find your leak to within inches, and you will be able to dig down, repair the line where it is broken, and repair it.
Boiler feed pump's suction pressure be aprox. 15Kg/cm2 and discharge pressure be 180Kg/cm2. So the balancing line balance the pressure and protect the boiler feed pump. my quastion is that what is the working principal of balancing leak off
The high pressure line is a high pressure hydraulic line. The can leak from the attachments to the fittings. The will leak where the line is damaged Or if it as a very old line they can crack.
depends where the leak is. In the brake line or at the pump? electric or mech brakes? if its in the line you should be able to replace the line section
It could leak while the filer is off. Once the filter is back on, there should be no leaks.
A pinhole leak or a valve on the line not shutting off properly and introducing air into the water line feed.
No. An electrical leak is an electrical ground. When any line grounds out, the circuit breaker will trip and shut the power off. With the power off the watt meter stops recording so that there is no billing at that time.
Repairing the section of pipe that is leaking will stop a leak on a hot water line.