0
Add your answer:
Earn +20 pts
Where is the switch under the brake pedal you cant find it?
It is above the brake pedal not under it. Follow the brake pedal bracket all the way up and you will see the brake pedal switch.
Where is the brake light switch on a 93 Dakota?
Just above the brake pedal, on the mounting bracket that the pedal pivots on.Just above the brake pedal, on the mounting bracket that the pedal pivots on.
Where is the Emergency brake pedal on a 1966 Thunderbird?
to the left of the brake pedal
How do you brake down the number 32?
Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.
What is meant by brake pedal pads?
It would be the rubber pad that sits on your brake pedal. Unless they were referring to brake pads, which are the pads which enables your vehicle to stop by pressing the brake pedal.
Where is the brake light switch on a 1997 chrysler sebring?
On the brake pedal bracket under the dash.On the brake pedal bracket under the dash.
What causes the brake lights to stay lit after the brake pedal is released?
manualy lift brake pedal to see if they go out. if so check spring at pedal
Where is the cruise control brake pedal switch on a 2002 Mercury villager?
On the brake pedal.
Can a brake pedal malfunction make your brake lights not work?
Usually that would be caused by a faulty brake light switch connected TO the brake pedal. If the brakes work the pedal is probably ok.
Why 1990 Geo Tracker brake pedal hard to press?
Hardness in the brake pedal can because by low brake fluid. Air in the brake lines can also cause the pedal to push hard.
Why does brake Pedal travel decreases and brake pedal get hard on ram van?
Probably the brake booster going bad.
Where is the brake light switch on a 1996 S10?
Above the brake pedal where the master cylinder is attached to the brake pedal assembly.
