Want this question answered?
The C represents the capacitance (in farads) of the capacitor. It is a measure of how much charge a capacitor can hold. This is needed to know how much energy the capacitor is holding.
Professional help from a chemical company that specializes in water treatment is recommended when a condenser must be cleaned.
3100y20q800cl
A Smoothing Capacitor is a capacitor which helps to smooth out fluctuations that may exist on a power supply line.
More information is needed to answer this question.
The capacitors in a generator is to store energy produced. They are also needed when starting the generator as a considerable amount of extra power is needed at this time.
Capacitor banks can improve the power factor if the load is leading, which is unusual. Typically in substations capacitor banks are employed to reduce over voltage.
4 ton
Do you know how to braze? Do you have an EPA license?Do you know how to pull a vacuum and recharge the system? There is a lot that goes into changing out an AC condenser. On average you are going to pay close to 1000$ just for the condenser. Do yourself a favor and pay someone who knows what there doing. If you don't you will be buying a new condenser before to long.
Possibly you have a broken shaft or you may have a problem with the condensers that are needed to get the motor turning in the first place. These are usually situated in a little box on the top of the motor. A: No broken shaft. The "condenser" is called a capacitor. If you can remove the motor take it into your local pool store and they can check the motor and capacitor. You then will need a new pump seal and gasket once you get your motor from the repair shop. k
Depending on voltage and amperage needed to run the motor,say,3volts.If you use a 3+volt capacitor what will happen is that the motor will turn once(not rev/min) and stop when the capacitor is completely drained which would occur in about half a second or less. Contributed writer:Dennis Wachira.
A capacitor in an air conditioner stores and releases electrical energy to help start the compressor and fan motors. It provides the initial surge of electricity needed to get these motors running and helps maintain a steady flow of power during operation. If a capacitor fails, the motor may not start or run efficiently.