Use new bolts !
(each step involves tightening all bolts in the right sequence)
Step 1 25 Nm
Step 2 Angle turn 60 degrees
Step 3 Angle turn 60 degrees
Step 4 Angle turn 30 degrees
Step 5 Warm up engine
Step 6 Angle turn 30 - 50 degrees
Tightening sequence cilinderhead bolts:
8 4 1 5 9
flywheelside
7 3 2 6 10
exhaust manifold: 25 Nm
Inlet manifold: 22 Nm
Valve-cover: 8 Nm
torque settings for cylinder head bolts
what are the torque for camshaft and cylinder head bolts please
What are cylinder head bolts torque settings for Isuzu kb240. Engine NAQ001716
How to torque cylinder head bolts kia k2700
Get a manual on your car and it will give you the settings of the intake, exhaust bolts plus the head bolts and torque pattern.
hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts
In four stages, 1st with a torque wrench then with an angular torque gauge. Note: when replacing the head gasket, you should replace the head bolts as well.25 n/m (18 lb/ft) + 70 degrees + 70 degrees + 50 degreesin my original daewoo manual says 25n/m +90 degrees+90 degrees+90 degrees daewoo nubira 2.0 2001
The cylinder had bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
torue sylinder head bolts volkswagen lupo
torque settings for mains,big ends and cylinder head Opel Corsa 1.7diesel 2000
in sequence torque bolts to 20nm, then again in sequence turn a futher 120 degrees, and again in sequence 120 degrees.
The torque settings for a 96 Fiat Punto 12cc for cylinder head bolts are 30 NM at 90 degrees. Then an additional 90 degrees.?æ?æ