answersLogoWhite

0


Best Answer

9 ft-lbs

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Oil pan bolts torque specs on b18a1?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the torque specs for 1995 Neon oil pan bolts?

9 ft lb


What are the torque specs for a 1987 Chevy S-10?

For the 1987 Chevrolet S-10 with a 2.8 liter engine, the torque specs for the cylinder head bolts is 40 ft. lbs. The torque specs for the crankshaft damper bolt is 70 ft. lbs. For the oil pump bolts and the oxygen sensor, the torque is 30 ft. lbs.


What are the torque specs for a Chevy small block oil pan?

Tighten the1/4 inch bolts 7-9 ft. lbs of torque, and the 5/16 bolts to 12 ft. lbs. torque.


What is the torque on oil pan bolts on 2001 Chrysler town and country?

The torque specs for the oil pan bolts are 105 inch lbs. Tighten all of the pan bolts snug to make sure everything lines up before tightening all of the bolts to spec.


What are the torque specs for the 350 oil filter adapter bolts?

7.5 lb-ft 90 lb-in 10.17 N-m


What is Ford 4.0 engine torque specs?

torque specs for rod and oil pan on 2005 4.0


What is procedure for oil pan gasket replacement on a 97 Saturn?

drain the oil from the vehicle, unbolt the oil pan, scrape old gasket from pan and crankcase. check the torque specifications for the oil pan bolts (shouldnt be very high). replace the gasket and oil pan to factory torque specs. put drain plug back in and fill with factory specs of oil.


Cylinder head torque specs for a 850 john deere tractor?

what is the torque head specs for a 3 cylinder diesel yanmar motor in a gator 6/4


How tight should bolts be so oil wont leak from valve cover?

Check the specs for the vehicle you are working on (You can find them on the net if you do not have the manual) and the torque requirements will be there. Do not over torque the bolts as removing a broken valve cover bolt is a pain. Good luck.


Specs for Oil Drain plug Torque caterpillar 3406?

The oil drain plug torque is 65ft lbs


What are the oil pan bolt torque specs on a C-12 caterpillar?

The oil pan bolt torque specifications, on your C 12 Caterpillar diesel engine, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.


Dodge caravan oil pan torque specs?

Be very careful when tightening the bolts holding any oil pan. It's not exactly rocket science, but all the bolts need to be tightened by hand, and all the same amount to avoid warping and possible cracks.