The 1995 Dodge Intrepid has two motor mounts. One on the left and one on the right.
Pdjby u
i took off the front tanny mount to replace it and i can't get the rubber out to change it with the one i bought from canadein tire.
One front, one left, and one right.
up till 1995 there where three, 1996 and later they use four.
The 1995 Dodge Neon engine mounts are located on each corner of the engine. There will be to engine mounts in the front and two engine mounts in the rear.
Yes there is enough room for the 440, but you would have to make new motor mounts, and driveshaft length would be an issue.
Noises have to be heard to be correctly diagnoised. Check the motor mounts to see if they are broken.
If the part has failed, yes you should.
It is best to change one motor mounts one at a time. Loosen the motor mount retaining bolt. Jack the engine up a few inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new bushing in and reverse the process.
Block and heads are the same, manifolds and sensors are different.
No, they are not the same.