0
How do you set the ignition timing on a 1986 350 without an advance timing light?
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Can you set timing without timing gun?
If you mean set ignition timing, generally not although with certain VWs you need a scan tool instead of a timing light. For any vehicle with adjustable ignition timing, there is a correct method for setting ignition timing which may require specific operating temperature and engine speed and possible unplugging something or pressing some buttons. If you just want to get ignition timing somewhere near reasonable on a carbureted engine with no electronic spark timing or advance, you can plug a vacuum gauge into manifold vacuum and turn the distributor until the vacuum reading is highest. A basic timing light can cost as little as $10 or so from an auto parts store and may also be available as a loaner tool. If you're talking about setting cam timing, a timing light is not used.
Where are the timing marks on a 1996 Chevy Corsica 2.2 engine?
There are none. Ignition timing is not adjustable. Ignition timing and spark advance are handled by the engine controller module and the ignition control module, with inputs from various sensors. The engine controller is located by the passenger kick panel. The ignition controller is the thing the ciol pack mount on...it runs about $110 new. The ignition controller is often the cause of rough running, or idle problems as the spark advance function tends to crap out on this model of DIS ignition. Producing a constant error code, and therefore a constant check engine light.
Why does your timing light shows advance on the harmonic balance?
Because the timing is advanced.
How do you advance the timing?
Normally by turning the distributor, in conjunction with a strobe timing light
When setting ignition timing on ford 302 5.0 engine does the rotor need to pointing to the number one on the distributor cap?
If you are setting the timing with a timing light then it don't matter where the rotor is pointing. But if you are putting the Distributor in then yes. When it is in, It must be pointing to #1 on cap so vaccume advance don't hit the thermostat housing when you adjust the timing with a light.
Do you need to unhook your vacuum advance when using the timing light?
YES! Any time you adjust the timing you should disconnect the vacuum advance.
What is the Ignition Timing setting for a 1974 Chevy 454?
The base ignition timing for a 1974 Chevy 454 engine is between 8 and 12 degrees below top dead center. A timing light is needed to accurate set ignition timing.
Ignition timing on mk3 golf gti 8 valve?
The question doesn't really make sense, but anyway... Timing mark is on the flywheel (open up the green cap), timing advance needs to be set at 6 degrees BTDC using a timing light. Hope i answered your non-question. lol
Why would a 2003 Ford Ranger 2.3 have an engine miss after replacing plugs wire and coil?
it could be that the timing is a little off check the timing with a timing light, it could also be the ignition module which is very difficult to test on your own you can take the module to advance auto parts and they can test it for you!
How do you advance the timing on your Peugeot 205?
Petrol engineYou really need a strobe timing light to set the timingThe timing marks are visable through an appature in the bellhousingTo advance the timing you need to rotate the distributor bodyclockwise.
What are the timing marks on a 1996 Subaru Impreza or how do you set it without the use of a timing light?
It should bethe same as a 1997 and there will be no way to adjust the timing as it is an electronic ignition. If you are changing the timing belt and looking for the top dead center marks (TDC) That is a different matter...
What instrument or instruments should be used to perform ignition timing on a running engine?
A dwell/ tachometer, and a timing light.
