answersLogoWhite

0


Best Answer

Replacing a thermostat is a relatively easy task. If your temperature gauge is running way down on the low side and your heater isn't putting out much heat, it's time to replace the thermostat. Here is a description of how to change a thermostat. The exact location of your thermostat may be slightly different but most of them are near the top radiator hose in the top of the engine. The thermostat is normally in a housing which is at the engine end of the top radiator hose. Drain the coolant into a drain pan - toss it down the john - it's the correct way to dispose of it. Take a screwdriver and remove the hose clamp from the top hose where it meets the top of the engine. Get a flashlight and see if you can peek down the hole and see the thermostat. If it is faulty it will be open. Not all thermostat housings are identical but typically it will be held on with two bolts. Remove them. Tap the thermostat housing with a wooden block or a soft faced hammer. It should pop off easily. You can then see the thermostat. Lift it out. Don't sweat the gasket - you are going to replace it anyway. Use a new gasket. Scrape EVERYTHING off both mating surfaces. Use a single edged razor blade. Apply some blue rubber sealant to both sides of the gasket. Then grab it between your fingers and "squeegee" any excess off. You don't need a lot of sealant. Make sure you put the gasket on the right side of the thermostat. The stat will normally fit into a recess in the engine, the gasket goes on top and the housing on top of that. Wipe a bit of blue rubber sealant inside the hose, put it back onto the housing nipple and clamp it back in place.

NOTE: Some Cavaliers do not have a traditional gasket but use a rubber ring around the thermostat. If this is the case with your model, do not use gasket sealant.

You should probably drain all of the coolant by draining the block but if you can't find the small plug it the side of the engine don't sweat it. You should mix antifreeze and water in a ratio of 50-50 and replace what you drained out with the fresh mix. If you can't get all the replacement mix in while it's cold just warm it up a bit and watch the level drop as the thermostat opens up. Then add mix until it is totally filled. Replace the radiator cap and put a quart or so in the overflow bottle (which you should have drained previously).

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the thermostat on a Chevy Cavalier?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the thermostat located on a 1994 Chevy Cavalier?

where do i find the thermostat for 99 cavalier


How do you replace a broken thermostat in a 2005 Chevy Cavalier?

Remove the water supply hose from the top of your 2005 Chevy Cavalier thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and drop in the new thermostat.


How do you replace the thermostat located on a 1988 Chevy Cavalier 4 cylinder automatic?

Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.


How do you replace thermostat on 2004 cavalier?

how do you replace thermostat for 2004 cavalier


How do you change the thermostat sensor on a 2001 Chevy cavalier?

how do you change a thermostat sensor in a 2001 Chevy cavalier and where is it


How do you replace the thermostat located on a 1991 Chevy Cavalier?

To replace the thermostat on a 91 Cavalier you need to drain the radiator. Remove the top radiator hose and water inlet. Remove the thermostat from under the inlet. Install the new thermostat and reinstall the inlet and hose. Fill the radiator with fresh antifreeze.


Why would a 2000 Chevy Cavalier run around 155 degrees on temperature gauge?

I would replace the thermostat. This sounds like the thermostat is stuck open.


How do you replace the thermostat on a 2002 Cavalier 22 Ecotec?

To replace the thermostat on a 2002 Cavalier 22 Ecotec, drain the radiator and remove the upper hose assembly. Replace the thermostat and refill the radiator.


How do you replace a thermostat on a 2004 Chevy Cavalier?

If it's an automatic you will have to remove the exhaust manifold because the thermostat is located on the backside of the engine on the driver's side under the exhaust manifold.


How do you remove and replace wiper switch on 2002 Chevy Cavalier?

How do you remove and replace wiper switch on 2002 Chevy Cavalier


How do you change the thermostat sensor on a 1989 Chevy cavalier?

where do I find it


Where is a thermostat located on a 2005 Chevy Cavalier?

It will be in the thermostat housing where the radiator house connects to your motor.