answersLogoWhite

0


Best Answer

This varies from car to car.

However, normally there are two screws holding the holder/lens cover on.

Take them out and with a little screwdriver or something just ease the holder out and then you should be able to twist and pull out the bulb holder.

After that, You twist and pull out the bulb.

I hope this helps, SJT.(sebbyfire)

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the license plate bulbs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a license plate bulb on a 2005 grand prix?

Open your trunk the two inner bulbs are for your license plate twist and should pop right out


How do you replace the license plate bulbs on a 1998 Chevy Blazer?

push up and turn on the housing


How do you replace license plate bulb on 2008 Pontiac G8?

You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825


How do you replace the license plate bulbs on a Honda Pilot?

The clear covers for the license plate light bulbs have small arrows pointing in one direction. Simply push the cover to the direction of the arrows and the covers will slide off allowing for the old light bulbs to be replaced.


How do you replAce license plate bulbs on 1998 buick lesabre?

If you can not remove fasteners on outside, you may need to cut a section out of the inside of trunk to get your hand by the bulbs.


How do you replace one of the rear license plate bulbs on a 2002 Buick Regal?

OPEN THE TRUNK LID. JUST INSIDE THE LID BEHIND THE LICENSE BULB CASE ARE 2 PHILIP HEAD SCREWS THAT REMOVE THE BACKING PLATE. ONCE YOU REMOVE IT YOU CAN REPLACE BOTH LITTLE BULBS. THEN PUT THE PLATE AND SCREWS BACK IN YOUR READY TO GO.....


How do you replace the light bulb that shines light onto the license plate on the rear bumper of a 2003 Chevy blazer?

Remove the screws that hold the covers in place. Replace bulbs!


How do you replace License Plate Bulbs on 2004 Nissan Sentra?

There are two (2) lights directly above the license plate. Each light has two (2) screws. Remove these screws and the covers. Lights pop out with little effort. Replace bad bulbs with size 194 lights. These are approx $2 at walmart or an auto parts store. Once bulbs are replaced, reattach covers with the screws and you should be good to go.


How do you change the license plate bulb on a 2001 ford escort?

On top of the license plate is a clear plastic lens with 2 screws in it. Take it off. Then a bulb slides into the holder, then replace the lens. There are 2 bulbs. One on each side.


How do you change the license plate bulbs on a 2000 Pontiac Sunfire?

in the rear facia, under the trunk lid there is 9 bolts holding the facia on. You must remove the nuts and pull the facia out and right above the license is the two bulbs 194. replace the bulbs and put the facia back on and you are on your way.


License plate lights out on 2003 Chevrolet avalanche?

Check bulbs


How do you change license plate bulbs on mercedes c280?

They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.