answersLogoWhite

0


Best Answer

You will need to look in your manual or online to find out how to fix the part. You can also contact the manufacturer for assistance.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a radiator on a vt commodore?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much to get brake pads replace on a holden vt commodore?

how much to get brake pads and rotors replaced on a holden vt commodore


How do you replace thermostat VT Commodore?

You will see that there are two pipes on your radiator. One is on top of your radiator and one on the bottom. The pipe that is on top of your radiator connects on your engine head with an G-clamp. You must take the G-clamp of and then you will see your thermostat.


Where is thermostat in VT commodore?

The thermostat is under the housing that is attached to the top radiator hose on the front of the motor.


How do you replace a head gasket on a vt commodore?

Replacing a head gasket on a VT Commodore instructions can be found in a manual. Manuals can be bought at most auto parts retailers or in book stores.


When was Holden VT Commodore created?

Holden VT Commodore was created in 1997.


How do you replace a vx commodore mirror?

http://forums.justcommodores.com.au/holden-commodore-how-tos/5541-removing-vt-vx-door-trim.html


Do you need the thermostat in a VT commodore?

YES, DO NOT REMOVE IT (Unless it is to replace a broken one)


Where is the turn signal flasher located on a Australian Holden Vt commodore 1999?

turn signal located on VT commodore


Where is the fuel pump in a VT Commodore How hard is it to replace?

The Fuel Pump in a VT is located in the Fuel tank, as in most cars. I think you need to remove the fuel tank to replace, obviously great care needs to be taken.


How do you replace vt commodore rear wheel bearing?

To replace a rear wheel bearing of a VT Commodore, remove the hub from the car and press it in and out. The bearing has an inner and outer seal. The inner seal has a magnet for the abs sensor. Make sure to install the new bearing before the abs will pick up a speed fault.


Vt commodore spark plug gap?

1.5mm


Is it fair to be charged 3 hours labor to replace a fuel pump in a VT Commodore?

That sounds about right on this vehicle. It is a very difficult job.