0
Add your answer:
Earn +20 pts
How do you remove the steering wheel on 2004 trailblazer?
A person needs a steering wheel puller to remove a steering wheel. It will help remove the steering wheel by putting pressure on the middle and by pulling up on the rest of the steering wheel.
How do you remove the steering wheel on a 2004 Mercury Monterey?
How do you remove the steering wheel from a 2004 Tahoe?
It is hard to remove a steering wheel by hand. A person needs to buy a steering wheel puller, follow the directions and it will pull the steering wheel off by applying pressure to the middle and by pulling up on the rest of the wheel.
Where is the headlight dimmer switch located on a 2004 Chevy Blazer S-10 and how do you replace it?
dimmer switch is on the turn signal lever, to replace you need to remove steering wheel
How do you remove brake rotors from 2004 Chevy silverado 5.3 4 wheel drive?
Front or rear, remove wheel, remove caliper, remove caliper bracket, remove rotor.
Steering wheel stiffens when turning sometimes 2004 Chevy trailblazer?
check the level of your power steering fluid. Also have a mechanic check to see if your power steering pump is working properly.
Where is the power steering reservoir on a 2004 Chevy Malibu?
There shouldn't be one. In 2004 Chevy went with electronic motor assisted steering.
Where do you add steering fluid on a 2004 Chevy cavalier?
On the right center area when the hood is open, there is a fluid cap with what looks to be a steering wheel on it. That is where you add the Power Steering fluid. Check your Owners/Operators Manual for a picture of it.
Where is the flasher located on a 2004 dodge Dakota 2wd?
The flashers are located on the top of the steering wheel like they would be in a 2005 Chevy trail blazer.
Where is the power steering pump located for 2004 Chevy Malibu?
Where is the power steering pump located for 2004 malibu
What do you have to do when you put a new clock spring in a 2004 Chevy S10 How do you set the clock spring?
start by removing the airbag assembly which will be attached by four screws on the back side of the steering wheel. Usually these are small torx bit screws. Once that is done you can carefully remove the airbag and then undo the wiring from the airbag (with the ignition OFF) After that remove the steering wheel insert and the clock spring is on the back side. Carefully remove it as to not damage the plastic retainer. Reverse these steps for install.
How you remove a front brake rotor on a 2004 Chevy Colorado?
The front brake rotor, on a 2004 Chevrolet Colorado, can be removed by first removing the wheel. Next, remove the brakes. The rotor will slide off
