the wheel bearing and abs are one unit. remove wheel, get some one to press brake and remove big drive bolt from drive shaft, using car brakes to lock drive shaft. need a large socket and a tobolar bar, say off a jack, to place in bar breaker. extra leverage.
remove abs cable disconnect off suspension strut, need to flict down a clip, off struct and between wire to remove. remove callipers, remove calliper bracket remove disc, remove corner bolt lover, remove ball joint bolt, may need a ball joint press tool, remove 2 supension struct bolts. the neck shot move lever off brackets and lower joints, pull slightly drive shaft amy come off gear box, easier to remove but place a container to catch clutch fluid. WD40 on drive shaft and wood on head and tap out with hammer, on neck 3 bolts remove, checkl pics on ebay for repalcement bearing and scrap parts. Mine was rusted and i belive it may need to be pressed out. Tools for Job, container catch clutch fluid, ratchet 18 mm sockets, Vectra socket for calliper bracket, allen key sockets, caliper, ball joint tools, large socket for drive shap bold and large ratchet, better if next size up from 1/2 inched, and jack pole to fit over, helper, spacer for caliper if using braked to releae drivce shaft bolt, rememember one caliper is off and will compress, press. Haynes manual has some good images swivel hub, beraing on vectra cost £50 (abs same unit) scrap 25-30. Section 10.4-10-7 helpful. My bearing was full rust abd crud.
yours silvervectra1, to also check on vectra owners club
how do i change the front bumper on my 1999 vauxhall vetra
under the front ashtray
32psi front 30 in rear
Send me photos of the front and back of the headlamp to the email address on my bio page, and I'm pretty sure we can figure it out.
on n/s front behind spoiler
The ecu unit in a 2002 Vauxhall Vectra is located in the engine compartment of the vehicle. The computer can be seen behind the engine in front of the firewall on the passenger side.
yes you can. but the front will sit way too high because of the different spring ratings with the v6 front springs having to carry alot more weight.
Pull the push pin out. This loosens the plastic guard surrounded the headlight. Pull the guard off. This allows you to remove the headlight assembly.
Good ones
unscrew the front grill then open the catch by hand. i fixed mine in 2 mins
take out glove box remove light for glove box it right in front
To remove the poor panel on Vectra the screwdriver that will be used to unscrew the screws. Once the screws have been removed, the door panel on Vectra can then be removed.