Yes you can bypass the immobilizer by keying in your current PIN followed by "C1C" on the keypad. This will allow you to start the car after unlocking with immobilizer and you only have 1 minute to start the car. To revert back to manual entry, just key in "C0C".
No.
There are several possible solutions to reset the immobilizer, assuming you can get into the car, the reset can be done by putting the key into the ignition and leaving the key there without starting the car.
The only way to bypass the immobilizer system on the Rav 4 is to have a master key. If there is no master key in you possession you will have to replace the whole immobilizer system at considerable cost.
Why would you want to bypass it? It helps keep your car from being stolen. If there is a problem or you need a key that works with it, just fix it and/or buy the key. A more detailed answer can be found here: http://wiki.answers.com/Q/How_do_you_remove_the_immobiliser_from_a_1995_Frontera_Sport By design it is difficult and expensive to remove this feature from a car.
check for key lock left hand front door jamb
The bypass operation is more difficult to complete than having a mechanic make new keys.
There is an immobilizer bypass unit (specific to your vehicle type) that must be wired to the remote start's brain and components of car. You must use one of your keys for this unit, so if you like having the number of keys you currently have you need to get another key programmed to your car (go to dealer), PRIOR to installing immobilizer bypass.
If the key is lost for a car which has a immobilizer system in place, you will need to contact the dealership. Most car keys have microchips in place to prevent auto theft. The car dealership will be able to order a new key to start the car.
go to your local stereo shop and ask for the immobilizer bypass kit and instructions for connect to your specific vehicle probably an IM04 or IM06 have the flash it with the latest bios, install this and then you can use any cut key for the ignition(such as a valet key)
Sometimes. The only reason you will usually need a key to program is for the immobilizer bypass module. Depending on the immobilizer used in the vehicle, some will require two keys to properly program the bypass module. This will depend on whether or not your vehicle has an immobilizer, and if it does, what kind it has. Professional installation is always recommended with remote starts, and the installer should be able to tell you if your vehicle requires two keys to program.
no is the quick answer. if it is because the key wont turn (very common on these) you can still start it by holding the key in the immobilizer pickup and turn the ignition switch with a screw driver but you might have to drill the retaining pin out of the lock barrel.