answersLogoWhite

0


Best Answer

Make sure the pump is full. Start the engine and turn the steering wheel fully to the left and then fully to the right. Repeat this procedure 10 times. Check the fluid level and add if necessary. Drive the vehicle for a few miles and repeat if you suspect there is air still trapped.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you bleed your power sterring pump on your 1995 Chevy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you bleed power steering pump on 1995 cavalier?

Power steering pumps are self bleeding, fill the reservoir, start the engine and turn the sterring wheel from stop to stop. Add fluid to correct level.


How do you bleed the power steering system on a 1995 Toyota Tacoma?

how do I bleed my power steering pete thank you


Where is the power window fuse on 1995 pathfinder?

I've read that there is no fuse--the windows are "controlled" by a circuit breaker next to the fuse box to the left of the sterring wheel.


Can you put a 1995 LT1 in a 1995 Chevy silverado?

A 1995 LT1 engine can be put into a 1995 Chevy Silverado with minimal changes. This will increase the overall power and performance of the vehicle.


Is the repair procedure for power windows in Chevy pickups from 1995 to 2001 all the same?

Yes, the repair procedure for power windows on Chevy pickups from 1995 to 2001 is the same.


Where is the power steering reservoir located on a 1995 Chevy Tahoe?

on the power steering pump.


Where to add power steering fluid on a 1995 Chevy Cavalier?

the power steering reservoir


1995 Chevy silverado 1500 4.3 V6 has no power?

Catalytic Converter is clogged.


What is the stock gear ratio for a 1995 Chevy Blazer?

The stock gear ratio for a 1995 Chevy Blazer is 3.73. This provides a good balance of fuel economy and power to the rear wheels.


When was Bleed Together created?

Bleed Together was created in 1995-11.


Backup lights on 1995 Chevy lumina not working no power in the wiring what can I do to fix it?

Take it to the garage.


How do your bleed a slave cylinder on a 1995 3.4 liter Chevy camaro standard transmission?

just bleed it like you would your brakes, the bleeder valve should be right on it, you could replace it with a speed bleeder to make it easier, or use a vaacuum pump