The short answer is yes, if it will do the job required. Why was 32 chosen in the first place? A thicker oil will not flow as easily, especially under cold start-up or cold weather conditions. It will generate more heat as it goes through valves etc. which stresses components and seals. It will increase the load on the pump, be harder to filter, and potentially reduce the lubricating capabilities overall. It can be done, and is done by some when operating conditions permit. It can also shorten the life of your system if it's not done carefully.
The Clark model GPS 20 MB typically uses AW32 or AW46 hydraulic oil. It is recommended to consult the operator's manual for the specific oil type and viscosity recommended by the manufacturer for optimal performance.
aw32
Engine oil = 9 qt Torque converter / reverser = 8 qt AW46 Transaxle = 19 qt or 20 qt AW46 (MFWD?) Reservoir = 44 qt AW46 These are refill volumes, more needed if lines are drained.
unscrew the bleeder screw
Check for kinked hydraulic lines (hoses or pipes)Bleed all lines and cylinders of trapped air.Check hydraulic oil level.Change hydraulic filter.Have oil pump rebuilt, or replaced with new.
Hydraulic fluid and hydraulic oil are one in the same.
hydraulic oil
emolliating hydraulic oil in the lowest part of the hydraulic system.
The best thing to use is the Bobcat "orange" Hydraulic fluid. Actually you dont use hydraulic fluid in a skid loader you need to use hydrostatic transmission fluid. Drive relief pressures are in excess of 5000 psi, the fluid needs to drive the machine as well as make the lift arm raise up and down. If you cant get the Bobcat stuff than use 10w30 or better MOTOR OIL. Dumping ISO 46 or AW32 can be a very costly mistake.
Hydraulic oil and hydraulic fluid are different. Hydraulic fluid is used in small systems such as car brakes. Hydraulic oil is used in large systems such as loaders.
fluid and hydraulic oil the same thing
Hydraulic jack oil Available at auto parts store or Wal-Mart Use AW68 grade hydraulic oil