answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Are there bottom bolts holding the radiator?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the radiator on an ef falcon?

disconnect bottom and top radiator hose then hose from filler tank, plus small overflow hose . unplug electric fans then undo 2 bolts at top holding radiator in then lift out with fans attached. no bolts at bottom only slots


How do you replace the thermostat located on a 1991 Nissan Stanza?

The thermostat is located under the alternator and is attached to the bottom radiator hose. There are four bolts holding the thermostat housing to the block and two bolts connecting the housing to the bottom radiator hose. Remove the housing. You will need to use liquid gasket maker as there are no longer gaskets for the thermostat.


How do you change the radiator on a Peugeot 206?

Drain the water from your radiator. Remove the top and bottom radiator hoses. Remove the radiator stabilizing bolts. Remove the radiator retaining bolts. Reverse the process to install the new radiator.


How do you replace a radiator on a 1986 1995 Taurus Sable?

given that you have general knowledge on socket tools/wrenches. all you need to do is locate the drain pipe usually on the bottom or bottom side of the radiator. make sure its fully drained so you dont make a big mess. take off the fan cover. locate the bolts holding the radiator in place remove said bolts. remove said radiator do steps in reverse to replace. congratulations you replaced a radiator!!! well done. p.s dont for get to refill the radiator ;)


Where is thermostat in 4D56 motor?

follow the bottom radiator hose which goes into the engine. where the rubber house stops is the thermostat metal housing with two bolts holding it onto the engine block.


How do you change a 2001 dodge Dakota auto transmission oil cooler?

remove fan and shroud, take off upper and lower radiator hoses. remove 4 bolts holding guard to radiator. pull on shroud and fan at the same time. pull out 4 bolts holding radiator to frame of truck, lean radiator toward the engine and undo the 2 lines going into that small box on ur left and pull the 4 bolts holding it to the radiator and it should b out


Where is the Toyota Sequoia thermostat located?

It is at the top of where the bottom radiator hose leads to out of the radiator. Three bolts (13mm I think) hold the casing. you have to take the radiator hose lose to get to the bottom bolt.


How to change a Ford Mondeo radiator?

The first step in changing a Ford Mondeo radiator is to loosen the clip holding the bottom hose in place and drain the system. Then loosen all other hoses and remove the radiator mounting bolts. Then perform the above in reverse, filling the system with the proper coolant.


How do you remove the radiator on a 1994 Dodge Intrepid?

First you must remove the cross support. This is across the front/top of radiator and is in your way. It is only four bolts. They all face up. Two on left, two on right. Secondly remove the two coolant hoses ( top left/bottom right) and the two transmission lines (right side top and bottom). Third remove the two bolts holding the radiator in (top left and right). These all face towards the front of the car. Now you can move the radiator, electric fans and a/c condensor around some. Fourth remove the four bolts that hold the a/c condensor to the radiator ( two on the right top/bottom, two on the left top/bottom). These four bolts face towards the front of the car. The top two you can get from above, the bottom two you will have to get at through the front of the bumper. Fifth remove the electric fans. Four bolts facing the engine. Top/ bottom left/right. You can now remove the radiator. Before putting the new one in remove and replace all of the bolt clips. There will be 10. Also replace the bushings at the top radiator bolts and the bottom and make sure that the old ones are goen or the radiator won't fit. That is it. When you remove the radiator from the car there are 4 bolts that you have to go trough the bumper to get to because they are connected to the air conditioning condenser. there is then two bolts to the frame at the top. and you have to remove the crossmember that has the hood latch on it to pull it out. that's how I got mine out (hope it's the same).


Where is thermostat located ea falcon?

Where the upper radiator hose connects to the engine you will find the thermostat housing. Under that housing is the thermostat. Usually has 2 bolts holding it on.Where the upper radiator hose connects to the engine you will find the thermostat housing. Under that housing is the thermostat. Usually has 2 bolts holding it on.


Where is the thermostat on a 5.7 Chevy Silverado?

Follow the top radiator hose, fronm the radiator, to where it ends at the motor. This housing, that has two bolts, accross from each other, holding it down, is the housing for it. Remove the two bolts, and there it is.


Where is thermostat on 2004 Dodge Durango?

At the bottom of the radiator there is a radiator hose that goes up to the engine. The hose runs into a housing with two bolts. Remove the two small bolts and the thermostat is inside.