Check your manual. There is a fuse for the seat motors, pretty sure it is independent of anything else.
I have the same problem on a 2000 ML320. The power passenger seat stopped moving and the fuse/relay panel has nothing labled as power seats.
Yes
Toyota MR2 cars have 2 seats and were produced in Japan. From 1986, seats were available in leather in addition to the original option. Production of these cars stopped in 2005.
All have back seats and some have power windows and some don't. Depends on the model.All have back seats and some have power windows and some don't. Depends on the model.
Power seats, power windows and power door locks are not fused. They would have a relay and or a circuit breaker. It should be in your owners manual.
The convenience relay that is located in the trunk of a Mercedes C280 may need to be replaced if the power seats are not working. Bad or loose wiring can be another cause for power seats to stop working.
Locate the bolts at the base of the seats and unbolt them. You'll have to disconnect any electrical connections if you have power seats.
You can switch the seats From a 2007 dodge ram to a 2005 with little to no problems. Switch in the seats are easy they bolt down with no problems, but the seatbelts will not work plug for the power seats will need to be modified. I switch the seats of my 2005 to 2007 quad cab last week. I did not have the power seats working yet And I had to switch the seat belts From the seats on the 05 to the seats on the 07.
There is no dedicated fuse for the power seats.
-------------------------------------------------------------------------------- Upgrading to power or power/heated seats (Laredo models) Power or power/heated seats can be added to most WJ's that came with standard seats. The entire seat assemblies will have to be exchanged. All seats use the same bolt pattern so the installation fit will always be exact. For power seat wiring, all that is required is a constant +12V wire and a Ground wire. Vehicles that came without power seats are not pre-wired. For the Ground wire it is probably best to run it over to the center console area where it can be attached to a metal bracket. Do not drill a hole in the floor below the seat. For the power lead, run a wire with an in-line fuse up to the fuse panel area where you can find a + wire to tap into. http://www.wjjeeps.com/seats/seats.htm
Power options: Power Windows, Power Locks, Cruise Control, Power Mirrors, Power Seats