answersLogoWhite

0


Best Answer

i accidentally hit the button sometimes and dont know it til i am going. a few times i have gotten into 4low because i hit the button and as i was switching to drive, i passed neutral and it jumped. my 95 you had to hesitate on neutral.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your 98 blazer jump into 4 wheel drive sometimes when you are backing up the control is on the dash it is push button 4 wheel drive where do you unplug it so it want be 4 wheel drive anymore?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Are zr2 blazer control arms and LT blazer control arms the same?

Yes!!


Where is the ignition control module located an a 1983 Chevy blazer?

Where is the control module located on the 1983 Chevy blazer


94 blazer transmission control module?

Where is the tcm in a 1994 chevy S10 Blazer


What is a Transmission Control System in a 1996 Automatic Chevy Blazer?

The 1996 Chevrolet blazer transmission control system helps the transmission to maximize optimal fuel consumption. The control system keeps the transmission in the overdrive gear.


How do you change the Ignition Control Module in a 1995 Blazer S-10?

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


How do you replace heater door control blazer?

The heater door control on a Blazer can be replaced by purchasing a new one. The heater vent will pop out with a little nudge from a flat tipped screw driver. Then insert the new heater vent door control.


How much freon does blazer hold?

If it's an S-10 Blazer, it should take 2lbs if it has climate control and 1lb 1.14oz otherwise.


How to check Lower Ball Joints on my 1989 S10 Blazer?

you insert a pry bar between the spindle and the control arm and pry to see if there is any play in the control arm if there is no play then its fine. (the nut gets loose sometimes). hope this helps! you insert a pry bar between the spindle and the control arm and pry to see if there is any play in the control arm if there is no play then its fine. (the nut gets loose sometimes). hope this helps!


Does a 1995 s10 blazer have a body control module?

yes on top of ecm


What is a IAC valve on a 97 s10 blazer?

Idle Air Control Valve


2000 Chevy blazer transmission control module located at?

it on the fire wall


How do you replace bulb on climate control for 05 trail blazer?

How to change the bulbs in the climate control for a 1999 Chevy trailblazer