there is a switch that trip when the brake is pulled. The switch itself is probably just stuck. Its nothing you need to worry about unless the light is just annoying. Another possiblity is that the emergency brake could be partially engaged and stuck. If this is the case you can free it up by getting under the car and tapping it bad with a hammer.
The 1994 Toyota Camry emergency brake light switch can be found beneath the drivers side dashboard. The emergency brake light switch will be beneath the far left hand side of the dashboard.
You need brake fluid
If your ABS emergency brake light and the track control light show up on the dashboard, you are having a brake problem.
Normally that light is an indication there is a problem with the brake system and MOST of the time that is low on brake fluid. There is a possibility (though remote) there is a problem with the switch on the emergency brake pedal.
If you mean the brake light in your dashboard, it means that you have your emergency break on while the car is on.
The dashboard brake light usually indicates a differential pressure malfunction between the two sides of the master cylinder, or that the emergency brake is on. Check the emergency brake, then check the master cylinder. You may need to bleed the brakes. You may need to reset the master cylinder, although they usually reset by themselves.
There is an electircal switch that 'senses' when the emergency brake lever is applied and lights a warning light on the dashboard to keep you from driving in this condition. This switch may be faulty or out of adjustment, causing the warning light on the dashboard to turn on.
How do you reset dashboard brake light on vw passat
Your emergency brake is to tight on the back brakes, which is not allowing the ABS to work properly. that's why both lights are on. Good Luck
emergency brake light stays on
The light on the dash that says the emergency brake light is on could have burned out if it does not light up when the emergency brake is actually on. In some vehicles, this light will not light up until the car is put into gear to warn the driver that the emergency brake is still on.
I'd check the sensor for the emergency brake. It's probably faulty.