Did you replace the thrown out bearing at the same time that you replaced the clutch? Are you sure that you seated the TO bearing correctly in the fork? Have you checked to make sure that your clutch slave and master cylinders are properly bled and functioning after the clutch change? Just a few things to get you started in the diagnosis of your problem. I will check back to see if I can help further ..... Good luck!! DB in TN
Engine RPM increases but not the speedometer.Difficulty engaging 1st gear at a stop. Clutch grabs to low or to high.
gear and clutch relation _ when clutch is disconnect this time gear shifting thats relation
Trouble code P0732 means: Gear 2 Incorrect Ratio
Trouble code P0733 means: Incorrect gear ratio, third gear Trouble code P0734 means: Incorrect gear ratio, fourth gear
Hyundai have added a trick to starting the engine - you need to have the clutch pedal in regardless of whether or not the car is in gear. Unless the clutch is in, the engine won't fire.
My hyundai wont go in gear the stick feels loose and wobbley whats wron ?
they burn the overdrive clutch or they have valve body problems.does it just go to freee rev in overdrive?
Of course you are coasting. The clutch has disengaged the transmission (no matter what gear) from the engine.
sometimes the spring on the clutch plate breaks off and will not engage fully to the flywheel or the pilot bearing is sticking not moving freely I had this happen to me on a suzuki sidekick 1989 could not put into gear while engine running but could when the engine was off ,testing by putting it in first gear and starting engine while putting my foot on the clutch pedal ,,will work but if you can no change to seconde gear then you have a broken spring in the clutch area,, hope this helps
The clutch is the pedal you press to change gear.
clutch slave cylinder.
push down on the clutch and move the gear stick forward and let the clutch out slowly