how do i reset timing belt light on 1hz
The fuel pump does not normally have to be "reset". If the vehicle is in a crash that causes the inertia switch to trip, the switch will have to be reset before the fuel pump will run.
Press in and hold the trip reset button. Switch on the ignition keeping the button pressed.
Not sure if this helps or not but on a 2005 Toyota Sienna LE, the dash-light dimmer switch is actually the trip odometer reset switch. Turning the trip odometer reset switch left or right controls the dash-light levels. Had it not been for the factory manual, and Google, I would have never known this.
Next to the odometer is a button. Press it to switch between odo and trip. While in trip, hold it to reset the tripometer.
Resetting the maintenance LightSwitch the display to the trip meter A when the engine is running.Vehicles with smart key system:Turn the "ENGINE START STOP" switch off.Vehicles without smart key system:Turn the engine switch to the "LOCK" position.Vehicles with smart key system:While pressing the trip meter reset button, set the "ENGINE START STOP" switch to IGNITION ON mode (but do not start the engine because otherwise the reset mode will be canceled).Continue to press and hold the trip meter reset button until the trip meter displays "000000".Vehicles without smart key system:While pressing the trip meter reset button, set the engine switch to "ON" position (but do not start the engine because otherwise the reset mode will be canceled). Continue to press and holdthe trip meter reset button until the trip meter displays "000000".
One interpretation of the term "trip switch" could be a reference to the emergency fuel reset / inertia switch.See "Related Questions" below
Not sure if this helps or not but on a 2005 Toyota Sienna LE, the dash-light dimmer switch is actually the trip odometer reset switch. Turning the trip odometer reset switch left or right controls the dash-light levels. Had it not been for the factory manual, and Google, I would have never known this.
MAINT REQD on means its time to replace your engine oil. The indicator lamp stays on until it is reset. To reset this reminder: While the ignition switch is on, but the engine is not running, move the trip selector to ODO. Push and hold down the trip selector push knob. Turn off the ignition switch, then turn on the switch. The reset will go through 000000.0 then ------, -----, ----, ---, --, -. once it runs through, release the trip selector knob. The MAINT REQD lamp goes out.
Press and hold down the trip reset button on the dashboard with the ignition switched off.Turn on the ignition while still pressing the trip reset button till you see zero on the screen. Switch off the ignition and it should reset your service clock.
Hi, to change it between the total miles and the trip meter you need to hold down the tube-like switch.....and to reset the trip meter you press it once (when you're looking at the trip meter - not the total miles)
Set the multi-information display to TRIP A. Turn the ignition switch off. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG). After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.