Sensor one is in the exhaust manifold on the back of the engine. Sensor two is in the side of the catalytic converter.
Disconnect the electrical connector, then unscrew the sensor. Installation is the reverse.
There is one in each exhaust manifold.
There is no such part.
Near the oil filter
if it auto transmission ,it in bellhousing ,takes reading off torque converter . i replaced mine when my van not start ,but did no good !! sensor in timing cover was the bad one ! on my 2001 Chrysler voyager
it's left hand side of engine underneath, very close to o2 sensors
where is crankshaft sensor located on 1999 plymouth grand voyager 3.0 litre
It is inside the distributor, under the rotor.
With an o2 sensor socket.
were is the cooling temperature sensor located on my 96 Plymouth grand voyager
A 2003 Chrysler van has two oxygen sensors in the exhaust pipe on the rear of the engine.