Want this question answered?
Be notified when an answer is posted
A bad relay switch could be the culprit if dash lights remain on after engine starts in a Toyota. Cold weather can also cause these lights to stay on after the engine starts.
Starts the engine. Turns on lights and radio.
Starts the engine. Turns on lights and radio.
There's a solinoid in the transmission.Suggest to check that first. Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.
Backhoe, bicycle, blender and bullhorn are machines. They begin with the letter b.
In a Manual, your car can stall at red lights because the engine is not receiving gas, this is why the klutch is important. In Hybrids the engine intentionally shuts off to preserve gas. Then an electric motor starts the car moving when you accelerate again, filling the time gap between when you press the accelerator and the gas engine kicks in.
Sounds like starter going bad.
I have the same problem when I first turn on the ignition there are no dash lights and it will start and die like yours. If I turn the switch on and off or just turn it on and wait, eventually I get dash lights and starts fine. There must be a relay or connection point causing this problem - anyone know where these are? Chuck Walp@juno.com
there is a clicking noise when I start engine starts no problem just curious of the clicking noist
Maybe you need to check the oil The oil light will stay on until the engine starts. If the oil light was on when it was running and now it will not start then you may have internal engine damage. Take it to a professional.
fuel filter
This is very normal. The extra drag on the engine caused by the alternator and the a/c causes the engine to slow. The engine speed is most likely then compensated by the e.c.u to a pre-set value, thus causing the revs to rise.