0
Most crankshaft sensors are located above the harmonic balancer next to the timing chain cover . Good Luck Workin Man's Auto Repair ,Akron OhioMost crank sensors are above the harmonic balancer (front) or left of bell housing on the engine block (rear)
Add your answer:
Earn +20 pts
Where is the backup sensor on a 2000 Dodge Durango?
The backup sensor is inside the transmission.
Where is the crankshaft sensor located on the 2000 Dodge Durango 4.7l?
opn pasenger side , near beel housing ,halfway down block. Remove tire and you will see it
What is the TPC on a 2000 Dodge Durango?
TPC= throttle position sensor.
What size is the crankshaft pulley bolt on a 2000 dodge durango?
it is a 1 1/4 ( hollywood)
Does the camshaft and crankshaft position sensors on a 2000 Dodge Durango 5.2 motor look the same?
No, the cam sensor is a flat plate under the distributor cap. The crank sensor is a round sensor with a mounting tab behind the passenger side cylinder head.
Where is the speed sensor located on the 2000 dodge durango?
The vehicle speed sensor is located on the top center of the rear axle.
Is a 2000 Dodge Durango equipped with PTO?
No, a 2000 Dodge Durango is not equipped with a PTO.
Where is the map sensor on a 2000 4.7 liter dodge durango?
The MAP sensor is located on the intake side before the intake manifold.
Where is the Rear wheel anti lock sensor located on 2000 Dodge Durango?
It is on top of the rear axle.
What is cmp or ckp on an 2000 Dodge Intrepid?
CMP : camshaft position sensorCKP : crankshaft postion sensor.CMP : camshaft position sensorCKP : crankshaft postion sensor.
How do you fix No camshaft signal detected during engine cranking on a 2000 dodge durango?
Replace the camshaft sensor
Where is the throttle position sensor on a 2000 dodge durango?
It is located on the throttle body, opposite of where the throttle cables hook on.
