Wiki User
∙ 14y agoThe crank shaft sensor is located on front of block above the harmonic balance wheel (bottom pulley on front of engine). This is easiest to get at from underneath the vehicle.
Wiki User
∙ 14y agoNo, The pcm has to see a signal from the sensor
GAS ENGINE The sensor is mounted on the bellhousing DIESEL ENGINE Bolted to the left rear side of the engine block
where is the crank sensor located on a 6.0l ford power stroke diesel
crank sensor
Front driver side of the crankshaft pulley.
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.
6.0 powerstroke had crank case sensor replaced by a dealership. 24hrs of runtime and engine refuses to start again. what happened to owning a reliable diesel??
It is behind the starter on the driver side of the engine.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
The crank sensor is located at the left front of the engine
No, it will crank, but it will not start.