0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace a crank position sensor on a 2001 Mitsubishi galant?
Where is the crank position sensor 0n a 2001 mitsubishi Galant
Where is the crank position sensor located on 2000 Mitsubishi Galant?
Behind harmonic balancer and timing belt on the 2.4 3.6-4 hrs
Where Is Crank Sensor Located 06 galant 2.4 liter?
not behind the bell housing ?
Where is the crank sensor located on a 1998 Mitsubishi 3000 gt?
there is no crank sensor on a Mitsubishi 3000 gt but there is a crank angle sensor that looks just like a distributor its in the back of the engine on top between valve covers
What does an angle crank sensor do in a Mitsubishi Galant?
Crank angle sensor reads rpm and sends the signal to the ECU (computer) to aid in the calculation of engine rpm, ignition timing, fuel injection and crankshaft position.
Where is the crankshaft position sensor located on a 1994 Mitsubishi 3000gt?
it is located on the drivers side at the the crank behind the covers
What causes no spark in plugs on a2000 Mitsubishi Galant?
pcm or crank sencer
Where is the crankshaft sensor on a 1998 Mitsubishi diamante?
it is located on the topside of the crank sprocket behind the timing cover.
Mirage 96 crank sensor?
The crank sensor on a 96 Mitsubishi Mirage is located on the bottom of the engine, near the oil filter. It constantly monitors the crankshaft and updates the vehicle's computer.
How do you replace a 95 Mitsubishi crank sensor?
how to ins toll a crank sensor on a 95 Mitsubishi 6v, but first of all my car crank to the point that it wanted to start but it does not start what might be the problem.
How do you change a crank shaft sensor on a Mitsubishi grandis?
First and formost be sure it is the cranksensor that needs replacement coz there is another sensor called knock sensor. Crank sensor is located near to the engine front pulley. Knock sensor is on the side of engine
Where is the crank shaft position sensor located on a 2000 Mitsubishi Eclipse?
behind the crank shaft pully and the timing cover and then another pully is there two bolt hold it on
