I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.
It is in the diistributor.
it is located on the head
that must be some metro to have a big block
The timing marks on a 1993 Geo Metro are located on the on the camshaft and crankshaft sprockets. They must be aligned together to ensure proper initial timing.
Does it have an ignition control module? That may be the cause. Or possibly a MAP sensor or a Crank position sensor or Cam position sensor. Check those first.
Yes, in fact it does. It is a hall-effect sensor which consists of a reluctor wheel and a pick-up coil inside the distributor. The ECM uses this sensor to decide when and how much to open the injector and also to adjusting timing/dwell electronically. -MechanicMatt
the seal on the crank shaft needs replaced
The amount of foot pounds required to torque a camshaft will vary based on the specific make and model of the engine. It is important to refer to the manufacturer's specifications for the exact torque specifications for your particular camshaft. Over-torquing can lead to damage, while under-torquing can result in loose components and potential failure.
It has 1 O2 sensor located on the exhaust manifold befor the catalytic converter
firewall, right side, has 1 elec. plug and one vac hose attached.
Metro State College is located in the state of Colorado.