where to place car jacks on 1995 honda accord lx
Look under the car and you will see what appears to be a frame built into the floor pan. Place the jack stands under those frame rails.
On the pinch welds, or frame.
On the frame rails.
The owner's manual will show you the points to place the jack. I suggest a floor jack and jack stands if you will be climbing under the car.
A Hyundai Santa Fe is reported by owners to need adapters when using jacks. The jack stands should be placed as directed by the factory on the jacking points.
front or back and what are you doing? if it is just to store you can use the jack points on the frame.
it is right under the intake manifold. its better to put the car on jack stands and crawl under.
place jack under vehicle just to the rear of the front tire's. Jack vehicle up using the frame of the vehicle. *Important* place jack stands under vehicle. I place them under the lower control arm's or on the frame (be sure to use stands that will support the weight of your vehicle). if unsure of the weight, there should be a vehicle identification tag on the driver's door jam that will tell you GVW (gross vehicle weight) on most vehicles. In the rear (if rear wheel drive) jack vehicle up by using the rear differential. When looking under the vehicle it will be the mass of iron centerly located between the rear tires. Again *Important* Use jack stands to support load of vehicle. place jack stands on the rear axle tube's and there u go!!
A 2003 Honda Accord Oxygen sensor is located on the exhaust pipe. To find it jack the car up and safely position it on jack stands. Crawl under the vehicle and look at the downpipe of the exhaust, the sensor will have two wires protruding from it.
it stands for jack the lad swings because it says in the jls official biography 2010
There is no aux input jack in Honda Odyssey 2007 model.