look on the drivers side firewall
Where is the clutch fluid on 1993 nissan pickup truck.
how do you remove the fan clutch on a 1994 mazda b 4000 4.0
At the top of the clutch pedal in the cab of the truck.
A 1959 truck has a mechanical clutch. A 1995 truck uses Dot 3 brake fluid for the hydraulic control.
In the clutch fluid reservoir located under the hood, on the drivers side firewall.
It is 750kg
Its Located Rite Behind The Engine. STUPID!!!!
The Mazda b3000 pickup truck does not have hydraulic fluid. None of the vehicles components use hydraulic fluid in any way.
Same as the brake they are both run off the same container in the top right hand side of the dash. Mine is a '99 model and most I have seen are the same.
To set the injector pump timing on a Mazda T3500 truck, you will need to follow these steps:Locate the timing marks on the flywheel and the injector pump gear.Rotate the engine until the timing marks on the flywheel and the pump gear align.Loosen the injector pump mounting bolts and rotate the pump until the timing mark on the pump gear aligns with the timing mark on the flywheel.Tighten the mounting bolts and recheck the timing marks to make sure they are still aligned.Start the engine and check for proper operation.It is important to note that the procedure may vary depending on the specific model and engine of your Mazda T3500 truck, and you may need to consult the vehicle's service manual for specific instructions. It's also important to make sure to have the right tools and expertise to do this job
check your clutch fluid level and your clutch slave cylinder for leaks,if both are ok,then you probly need a new clutch.