0
Add your answer:
Earn +20 pts
Where is the connection point for battery ground cable on a K1500?
You can connect the battery ground cable to the frame of the vehicle or to the engine.
How do you hook up a 1990 ford f150 battery?
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
What do the battery cable's on a 76 CJ5 258 6cyl connect to?
The starter, +, and a good ground, -.
How do you replace Chevy Cavalier battery ground cable?
Unhook the cable from the Cavaliers battery. Find the opposite end of the cable and pull it out. Fit the new cable in following the old cables route. Connect the non battery end of the cable, then hook to the battery.
Do you connect the ground cable first on a car with a positive ground system when installing a battery?
No, the ground cable gets always disconnected first and connected last, regardless of ground polarity.
How do you replace positive battery cable on 1997 Ford F150?
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
How do you put 2 6 volt batteries into a Series circuit?
Take the # 1 battery and connect the positive cable to the vehicle. Then connect the negative cable on # 1 battery to the positive post on battery # 2. Finally connect the negative post on battery # 2 to ground on the vehicle. You will have 12 volts but only the amperage of #1 battery.
When jumping a car why do you have to put the negative cable on ground?
You connect the negative cable last and connect it to ground rather than to the negative post of the battery because there may be a small spark when you make the connection. Batteries can emit a slight amount of highly explosive hydrogen gas. That spark on the negative post can cause these fumes to ignite and explode. That is why you always connect the negative cable last and always connect it to ground and not to the battery itself as a safety measure.
How do you connect two 12 volt batteries into a 24 volt hitachi ex60 excavator?
Connect the two 12 volts batteries in Series. Battery 1 & 2. Connect the negative post (-) of battery 1 to the negative (-) ground cable. Then connect the positive (+) post of battery 1 to the negative (-) post of battery 2. Connect the positive (+) post of battery 2 to the positive (+) cable. You now have 24 volts as the batteries are wired in series.
How do you hook back up a car battery?
Connect the Positive + battery cable to the positive + battery post first. Then connect the Negative - cable to the negative - battery post.
What would cause no voltage through the entire car after transmission change?
Forgot to connect ground cable? Shorted Fusable link battery + cable not connected
Does the Negative ground cable for the battery go on the block on a 99 mercury cougar?
Yes. You can connect it to the block or the frame of the vehicle.
