The headlight adjustment screws are found in 2 holes behind each headlight, through the air shield. They are gold star shaped bolts.
The are adjustment screws next to the headlight housings. To adjust the headlights either loosen or tight the screws. This will either raise or lower the headlight unit.
I need a diagram of the headlight adjusting screws.
The headlight have adjustment levelers on the top and bottom of each headlight. Adjust the headlight up or down with the adjustment levelers.
No adjustment. If there is valve clatter, valve train parts are worn.
8mm
To adjust the headlight assembly on a 2002 Montana Van you will need to loosen the side adjuster screws located to the left and right of the headlight. With the lights on use a garage door or solid foundation to see if the lights are level. Once you have the headlight in a desired position tighten the adjuster screws to secure the light in place.
remove front headlight assembly to get at horn,it is down below light assembly..
I did some searching on the internet for the same thing ,headlight aiming on my 2003 Impala. I found out there are no horizontal aiming screws (thanks GM) and the vertical ones are the screws on the top of the headlamp assembly. Just pop your hood and you should see those vertical screws no problem.
open the hood and look on top of the light. three screws right there , almost in a triangle 8mm socket should get it.
What fuse for 2002 Malibu theres about 50 to 60 fuses
The 2002 Chevrolet Malibu has 12 valves.