First thing I would do is check the fluid level in the Master Cylinder, and bleed the brakes. Start at RR, then LR, RF, and end up at LF, making sure you keep the Master Cylinder full at all times. If that does not help, replace the Master Cylinder.
First thing I would do is check the fluid level in the Master Cylinder, and bleed the brakes. Start at RR, then LR, RF, and end up at LF, making sure you keep the Master Cylinder full at all times. If that does not help, replace the Master Cylinder.
First thing I would do is check the fluid level in the Master Cylinder, and bleed the brakes. Start at RR, then LR, RF, and end up at LF, making sure you keep the Master Cylinder full at all times. If that does not help, replace the Master Cylinder.
how do you adjust rear brakes on a 1986 chevy silverado?
First id have to get my back brakes on your Chevy 2500 silverado.
The 1997 Chevrolet Silverado rear brakes should automatically adjust themselves. Every time you back the vehicle up and hit the brakes the brakes adjust.
No, they use air pressure or actually the lack of air pressure to stop the vehicle. The brakes are fully on until pressure builds up in the tank releasing the brakes. When you push the brake pedal this removes air from the system and applies the brakes.
It means there is a pressure difference between the front and rear brakes when the brake pedal is depressed. It will not reset until the pressure difference is repaired or eliminated. Check for low fluid/ air, rear brakes adjustment or bad. Front brakes bad, Bad master cylinder internally leaking pressure, etc.
Remove the original brakes and in stall it slowly.
you change the brakes,check brakes fluid,bleed the brakes why is hard to stop in a 1988 sliverado?
You can't adjust disc brakes
1997 wheels on 2000 silverado? the wheels are the same, drum or disc. /
Drum brakes are cheaper to build.
2007chevy silverado 1500 .6.0 engine ;four weel drive
That all depends on several variables. Is it driven in the city or mostly highway? Quality of the pads, shoes, rotors, etc installed? What kind of driver are you? Do you run 90 mph stop light to stop light and slam on the brakes or do you anticipate stopping and use the brakes as little as possible? How about riding the brakes? Towing a trailer?