answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: When removing cylinder heads the fasteners should be removed in what order?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What should be removed first before removing top cover?

remove guy ropes


Can you re-use a head gasket after removing it from the cylinder?

its recommended you replace the gasket when the head is removed, but if you don't and it does go wrong after refitting you will be doing the job twice for the sake of a few quid, also you should replace the timing belt when refitting,


Should the cylinder ridge be removed before the piston?

No, you dont need to remove the cylinder ridge before. I never have and i replace them all the time.


What is mslgqlajdll?

It is a virus and should be removed from your computer immediately. See related link for some guidance on removing it.


How do you remove a Saturn vue headrest?

I just removed mine. There is a small hole on one of the plastic fasteners. You just push either a screw drive or hanger in it and the headrest should come all the way out.


How do you remove rear struts on Camry?

The rear struts can be removed, on your 2005 Toyota Camry, by removing the nuts on each end of the strut. With the nuts removed the strut should slide off of the stud.


How do you remove rear struts on 2005 Camry?

The rear struts can be removed, on your 2005 Toyota Camry, by removing the nuts on each end of the strut. With the nuts removed the strut should slide off of the stud.


Remove interior door panel 2006 GMC Sierra?

The interior door panel, on a 2006 GMC Sierra pickup truck, can be removed by removing the retaining clips. The door handle should also be removed.


Where can you find replacement trim fasteners for your 1986 Ramcharger?

Any auto parts store should have a rack of DORMAN fasteners. You can find the part number at www.dormanproducts.com


How do you replace the starter in a 1995 Grand Am SE 4-cylinder you can't reach the bolts should you be removing other parts to get to it Thanks?

should be able to get to them with an extension about 2 feet long with a wobbly on it.


When do you need to shim the flywheel on a 91 Chevy?

If the clutch system uses hydraulics, the flywheel should be shimmed the amount that was removed. Removing material from the flywheel moves the pressure plate away from the throwout bearing by the amount that was removed.


Where can someone find more information about removing sutures?

Sutures, also known as stitches, should always be removed by a health care professional, never by the patient themselves. A comprehensive guide to removing sutures can be found on Emedicine Health.